Tascam DR-2d Release Note

Updates
Always use the most recent firmware for this device.
Please visit the TASCAM web site at http://www.tascam.
com to check for the latest firmware.
Maintenance items
V1.01 changes
•
Battery life has been improved by optimizing the
firmware.
•
The sound quality of low volume intervals during MP3
recording has been improved.
•
Some MP3 files did not play back correctly. This
problem has been fixed.
Confirmation of firmware version
Confirm the firmware version of your DR-2d before
conducting a firmware update.
1 Turn the unit's power ON.
2 Press the MENU key to open the
3 Using the wheel to select
item (highlight the item), and press ENTER/MARK
key to open the
INFORMATION
4 Turn the wheel to open the
and confirm the
System Ver.
is displayed.
You do not need to update the unit's firmware if
the version shown is the same as or newer than the
version that you intend to use for the update.
Firmware update procedures
NOTE
When you updated the firmware, make sure that the
batteries have enough remaining power or use an optional
AC adaptor (PS-P520). The program has been set so that the
update will not be conducted if battery power is insufficient.
1 Download the most recent firmware from the
TASCAM web site (http://www.tascam.com).
2 Turn the unit's power ON and use the included
USB cable to connect it with a computer. This unit
will be recognized as an external drive (external
storage device) by the computer.
3 Copy the downloaded firmware to the UTILITY
folder on the DR-2d.
4 After copying has completed, disconnect the
unit from the computer following the correct
procedures, remove the USB cable and turn the
unit power OFF.
D01134300A
screen.
MENU
menu
INFORMATION
screen.
page
SYSTEM (3/3)
(firmware version)
DR-2d
Release Notes
5 While pressing and holding both the MENU and
PLAY/PAUSE (Á/π) keys, turn the unit power ON.
The unit starts up in update mode, and the update file
appears on the screen.
NOTE
•
If this screen does not appear, turn the power OFF. Then
while pressing and holding both the MENU and PLAY/
PAUSE (Á/π) keys, turn the unit's power ON again.
Continue to press and hold the MENU and PLAY/PAUSE
(Á/π) keys firmly until this screen appears.
•
When firmware has been copied to this unit's UTILITY
folder from a Mac, in addition to the firmware file itself,
another file with "._" added to the beginning of the
firmware name is also shown. Use the file without the "._"
at the beginning of the name.
This screen shows a list of the firmware update files inside
•
the UTILITY folder of the unit. Also, the screen shows the
firmware copied at Step 3 above. "No Update File" appears
if there is no update file in the UTILITY folder.
The screen shown is an example. The actual display differs.
•
6 Select the firmware (highlight the item) then press
ENTER/MARK key.
The following screen appears.
The current version appears on the left and the
updated version appears on the right.
NOTE
The screen shown is an example. The actual display differs.
7 Press the ENTER/MARK key to start the update.
8 When the update is complete,
appears at the bottom of the screen and the power
turns OFF automatically. Turn the power ON again.
9 Follow the "Confirmation of firmware version"
instructions above to check that the
is now the most recent version of the
Vers.
firmware.
This completes the procedure for updating this unit.
10 Connect to a computer with USB and delete the
firmware update from the unit's UTILITY folder.
Update Complete
System
1
TASCAM DR-2d