Table of Contents
Advertisement
Trouble
Shooting stops by itself.
Images on the LCD monitor and
viewfinder screens appear dark
or blurred.
The subject is too dark.
The color of the subject looks
unnatural. (Reddish, bluish,
etc.)
Focus is not adjusted
automatically.
White balance cannot be
adjusted.
Screen appears dark or whitish.
Screen display is difficult to see.
The remaining battery power is
not correctly displayed.
Screen display is uneven.
No display on the monitor.
File (image) does not play back
when its thumbnail is selected.
The actual recording time is
shorter than the estimated time.
Shooting may stop halfway due to the nature of the SDHC/SDXC card.
0
B Check whether the card is a recommended SD card (Class 6 or higher).
"SDHC/SDXC Cards" (A p. 11)
BErase the contents of the SDHC/SDXC card (Delete, Format).
"Formatting (Initializing) SDHC/SDXC Cards" (A p. 30)
Readjust the brightness of the LCD monitor screen.
0
" MONITOR BRIGHTNESS " (A p. 64)
Is the aperture setting too large?
0
Is the shutter speed setting too high?
0
Set exposure to the "+" side.
0
"Adjusting the Exposure Manually" (A p. 38)
Set to the manual shooting mode and increase the sensitivity using the [GAIN] switch.
0
"Setting to the Manual shooting mode" (A p. 32)
Set "GAIN L", "GAIN M", and "GAIN H" in the recording menu to "AGC" or "AUTO SLOW-SHUTTER".
0
(A p. 61)
Set the shutter speed to a slower value.
0
"Adjusting the Shutter Speed" (A p. 39)
Set to open up the aperture.
0
"Adjusting the Aperture" (A p. 40)
Depending on the lighting conditions or when there are numerous light sources in the background,
0
set to the manual shooting mode and perform auto white balance adjustment.
"Adjusting the White Balance" (A p. 41)
Clean any dirt or water droplets from the lens.
0
If you are shooting at a dark place or shooting a subject that has no contrast between dark and light,
0
adjust the focus manually.
Is the camera recorder in the Full Auto shooting mode?
0
Adjust the angle and brightness of the screen.
0
"Viewing the Viewfinder/LCD Monitor" (A p. 31)
When used in cold places, the screen may appear darker.
0
The screen may be reaching the end of its service life. Consult your nearest JVC dealer.
0
The screen may be difficult to see if used in bright areas, such as under direct sunlight.
0
Charge the battery fully, use it up, and then charge again.
0
"Charging the Battery Pack" (A p. 24)
If the camera recorder is used for long periods of time in high or low temperatures, or if the battery is
0
repeatedly charged, the remaining battery level may not be displayed correctly.
If the screen or surrounding parts have been pressed, remove your hands and leave the camera for
0
a short while.
(Applying pressure causes image unevenness.)
Connect all the four [HDMI] terminals to the monitor during output of video in the 4K2K mode.
0
[HDMI2] to [HDMI4] terminals can only be used for 4K2K video output.
0
For output of Full HD (1920) or lower, connect only the [HDMI1] terminal to the monitor.
0
Is the selected file (image) a playable file (image)?
0
A file with a different video format setting cannot be played back.
The recording time may be shorter depending on the environment, such as when shooting a fast-
0
moving subject.
Further Information
Action
67
Advertisement
Table of Contents
