Reducing Wind Noise; Monitoring Audio Sound Using A Headphone - JVC GY-HMQ10U Instructions Manual

Shooting
Adjusting the audio recording level
o
Select a method for adjusting the audio recording level.
Set the [CH1/CH2 AUDIO SELECT] switch.
0
Select whether to set each channel to the [AUTO] or [MANUAL]
0
mode.
AUTO:
Use this setting to enable the auto adjustment mode.
MANUAL:
Use this setting to enable the manual adjustment mode.
Adjust the audio recording level using the [CH1/CH2] recording
level adjustment knob.
[CH-2 INPUT ]
AUTO MANUAL
CH-2 INPUT AUDIO INPUT CH-1
AUDIO
INPUT1 - LINE -
- MIC - SELECT
INPUT2 MIC+48V
INPUT1 INPUT2 CH-2
AUTO MANUAL
FULL AUTO A E
A F
M F
SET SHUTTER
[CH1/CH2] recording level adjustment knob
ADJ.
GAIN WHT. BAL IRIS
L- B -
M- A -
H- PRST
DOOR LOCK
.

Reducing Wind Noise

Wind noise for each microphone can be reduced.
Menu setting
o
Set each of the items on "WIND CUT" in the recording menu to "ON".
"WIND CUT" (A p. 62)
46
[CH1/CH2 AUDIO SELECT ] Switch
AUTO MANUAL
CH-1
CH-2 INPUT AUDIO INPUT
AUDIO
- LINE -
INPUT1
- MIC - SELECT
INPUT2 MIC+48V
CH-2
Switch INPUT1 INPUT2
AUTO MANUAL
[AUDIO INPUT 1/2 ] Switch
Monitoring Audio Sound Using a
Headphone
Applicable to: Camera mode and Media mode
1
Connect the headphone.
Connect the headphone to the headphone jack.
0
.
2
Set the headphone sound to mixed sound or
stereo sound.
Set "AUDIO MONITOR" in the recording menu.
0
("MIX"/"STEREO") (A p. 63)
3
Adjust the volume level of the headphones.
Operate with the [ADJ.] knob.
0
FULL AUTO A E
A F
M F
SET SHUTTER
ADJ.
GAIN WHT. BAL IRIS
L- B -
M- A -
H- PRST
[ADJ.] Knob
.
Memo :
The built-in speaker is usable only in the Media mode. Audio is
0
not output from the built-in speaker during Camera mode.
Audio level in the Camera mode and Media mode can be
0
adjusted separately.
When in the Media mode, the volume of the headphone and
0
speaker are adjusted at the same time.
The built-in speaker cannot be used when the headphone jack
0
is connected.
Headphone jack
DOOR LOCK