Advertisement
D. Finnally, ensure that the arrow mark on the Indicator [114] is properly aligned with the 0˚ setting of the Scale
[89], and tighten the two M5 x 10
(2) Cutting Depth Adjustment:
The adjustment procedures and dimensions described below are based on the use of a 380 mm diameter Saw
Blade.
A. Cutting depth adjustment procedures are described in the Instruction Manual. If the M10 x 40 Bolt [95] is
not properly adjusted, the following may occur:
•
Maximum machine cutting capacity cannot be obtained.
•
The Saw Blade could cut into the Turn Table [87].
B. To obtain maximum machine cutting dimensions, set the Turn Table [87] to the 0˚ setting, lower the Saw
Blade, and perform adjustment with the M10 x 40 Bolt [95] so that the appropriate dimension between the
surface of Vise (B) and Point A (where the Saw Blade intersects the surface of the Turn Table) is
obtained, as illustrated below.
Vise (B)
90˚
(0˚ Scale
Setting)
Saw Blade
C. On completion of the above adjustment, lower the Saw Blade and ensure that it does not come in contact
with the Turn Table.
(3) Saw Blade Height Setting Adjustment:
Vise (B)
1-4. Confirmation of Appropriate Insulation:
When making leadwire connections, do not remove any more of the insulation covering than is absolutely
necessary. For example, ensure there are no exposed wire cores projecting from connectors, terminals, etc. In
particular, carefully confirm that there are no exposed wire cores at the terminals of the Switch. In addition,
carefully avoid pinching leadwires between the Handle and Handle Cover during reassembly.
-Hd. Machine Screws [113].
(Point A)
Saw Blade
Workpiece
Check this dimension
at 0˚ Scale Setting
When the Gear Case [53] has been disassembled and then
reassembled, adjust the M10 x 40 Bolt [95] without fail to
set the Saw Blade at the most appropriate height (H) above
the Turn Table for the operator to conveniently perform
normal cutting operations. Details concerning adjustment
procedures are listed in the Instruction Manual; study them
carefully, and set the height in accordance with cutting
needs.
--- 6 ---
Saw Blade
185 mm
(Point A)
Advertisement
