Advertisement
(2) Disassembly of the Spring Section and the Sleeve:
Tools Required:
•
17 mm Wrench, 10 mm Wrench, 6 mm Hex. Bar Wrench, and
Plus Screwdriver
A. This step of disassembly is dangerous and requires close
attention at all times. Particular caution is necessary after
releasing the fixing device (paragraph D.).
B. Push the Gear Case [53] forward and down to its lowered
position, and lock it in that position with the fixing device
(push in the Set Pin [97] to engage the Grip [100]).
C. Loosen the M10 Lock Nut [96], and screw the M10 x 40 Bolt
[95] fully into the Hinge [119].
D. Being very careful as cautioned above, release the fixing
device (Set Pin [97] and Grip [100]) and slowly and carefully
raise the Gear Case [53].
E. Loosen the two M6 x 10 Hexagon Socket Hd. Set Screws
[54], and remove the M12 Lock Nut [92] and M12 Nut [93].
Next, gently pull out the Hinge Shaft [102]. Finally, loosen
the two M4 x 10 Flat Hd. Screws [65], take off the Spring
Cover [68], and take out the Spring [67] and Sleeve [69].
(3) Disassembly of the Saw Cover Section:
Tools Required:
•
Plus Screwdriver
The Saw Cover Ass'y [3] can be disassembled by removing the
M4 x 10
-Hd. Machine Screws [15] and four D5 x 90
Tapping Screws [13] However, please note that to remove two
of the four D5 x 90
to insert the screwdriver through the holes at either end of the
Arrow Mark on the Saw Cover which indicates the rotational
direction of the saw blade.
-Hd. Tapping Screws [13] it is necessary
-Hd.
--- 2 ---
Insert screwdriver through
Arrow Mark holes for
disassembly and reassembly.
Advertisement
