Dell PowerEdge 2500 Installation Manual page 7

Align the tabs on side of the peripheral bay with the locking slots in the chassis and
3
slide the peripheral bay forward.
Tighten the thumbscrew securing the peripheral bay to the chassis (see Figure 1-1).
4
2
Installing the
I C Extension
2
Disconnect the I C cable connector at the 20-pin PLANAR connector on the system
1
board.
Do not disconnect the end that is connected to the SCSI backplane.
In the customer kit, locate the I
2
20-pin connector on one end, a 10-pin connector on the other end, and a 20-pin cable
connector in the middle (see Figure 1-3).
NOTE: Figure 1-3 shows the 1 x 2 backplane and its drive cage oriented for a tower
system. For rack systems, you must install the 1 x 2 backplane and its drive cage oriented
180° from the position shown in Figure 1-3.
F i g u r e 1 - 3 . I n s t a l l i n g t h e
2
10-pin I C connector
2
20-pin I C connector
on system board
Cable
2
C extension cable. This cable has three connectors: a
2
I C
E x t e n s i o n C a b l e
1 x 2 Ba ckplane Ki t Inst allat ion Gu i d e
power connector
nonterminated
SCSI cable
cooling shroud
cable clips
1-5