Ice Machine Care - Sub-Zero UC-15I Use & Care Manual

Ice Machine Care

Cleaning
CLEANING AND SANITIZING
Cleaning and sanitizing of all surfaces that come in
contact with the water system should be performed every
six months. The following steps outline the cleaning and
sanitizing procedure with the ice machine in place.
Use only the cleaner and sanitizer made for your Sub-Zero
ice machine. The cleaner removes lime scale or other
mineral deposits and the sanitizer disinfects and removes
algae and slime.
If the ice machine requires more frequent cleaning and
sanitizing, consult a qualified professional to test the water
quality and recommend appropriate water treatment.
An abnormally dirty ice machine must be disassembled
for proper cleaning and sanitizing by Sub-Zero factory
certified service.
Use only the Sub-Zero approved ice machine cleaner
and sanitizer and follow all label directions and
warnings. Damage to the ice machine evaporator
caused by incorrect chemical usage is not covered by
the warranty.
WATER
SHUTTERS
Location of water shutters.
1) Add 4 ounces
(115 ml)
to a container that will fit under the lifted water
shutters. Refer to the illustration below.
2) Press the CLEAN key pad. The ice machine will initiate
a two minute harvest to remove any remaining ice from
the evaporator.
3) Remove all ice from the bin.
4) Wait three minutes until the CLEAN light flashes, then
add the prepared cleaner by lifting the water shutters
and pouring directly into the spray area.
5) The ice machine will automatically time out a ten
minute cleaning cycle, followed by eight rinse cycles,
and stop. The CLEAN light will turn off to indicate the
cleaning cycle is complete. This entire cycle lasts
approximately 30 minutes.
6) Add 1 tablespoon
(15 ml)
tizer to a container that will fit under the lifted water
shutters.
7) Press the CLEAN key pad. Wait three minutes until the
CLEAN light flashes, then add the prepared sanitizer by
lifting the water shutters and pouring directly into the
spray area. The ice machine will automatically time out
a ten minute sanitizing cycle, followed by eight rinse
cycles, and stop. The CLEAN light will turn off to
indicate the sanitizing cycle is complete. This entire
cycle lasts approximately 30 minutes.
8) The ice machine will automatically continue from the
previous point before the cleaning cycle was initiated.
If the ice machine was in the ice making cycle, the
control board will start ice making again. If it was in the
off cycle, the control board will turn off.
subzero.com
of undiluted ice machine cleaner
of undiluted ice machine sani-
9