Part Names - Hitachi CP-A301N User Manual

Introduction

Part names

Projector
(1) Lamp cover (92)
The lamp unit is inside.
(2) Control panel (5)
(3) Elevator feet (x 2) (23)
(4) Remote sensor (16)
(5) Lens (97)
(6) Intake vents
(7) Filter cover (94)
The air filter and intake vent
are inside.
(8) Battery cover
The internal clock battery is
inside.
(9) Speaker (12, 20, 46)
(10) Exhaust vent
(11) AC IN (AC inlet) (14)
(12) Ports (5)
(13) Security bar (14)
(14) Security slot (14)
(15) Lens door (97)
(16) Mirror (97)
(17) Spacer (Small) (23)
(18) Spacer (Large) (23)
WARNING
vents during use or just after use, since it is too hot.
►Be careful not to pinch your finger with the lens door, to prevent an injury.
►Never look into the projection lens or mirror while the projection lamp lights,
since the projection lamp ray may cause a trouble on your eyes.
►Do not use the security bar and slot to prevent the projector from falling down,
since it is not designed for it.
CAUTION
heating up. Do not cover, block or plug up the vents. Do not place anything that
can stick or be sucked to the vents, around the intake vents. Clean the air filter
periodically.
4
►HOT! : Do not touch around the lamp cover and the exhaust
►Maintain normal ventilation to prevent the projector from
(1)
(4)
(7) (6) (8)
(17)
Small
(3)
(5)
(15)
(2)
HOT!
(16)
(12)
(14)
(11)
(13)
(10)
HOT!
(18)
(9)
Large
(15)