Asus CUWE-RM User Manual page 37

3. HARDWARE SETUP
15) Serial and Consumer IR Connectors (10-pin IR_CON)
This connector supports an optional wireless transmitting and receiving infra-
red module. This module mounts to a small opening on system cases that sup-
port this feature. You must also configure the setting through UART2 Use In-
frared (see 4.4.2 I/O Device Configuration) to select whether UART2 is di-
rected for use with COM2 or IrDA. Use the five pins as shown in Back View
and connect a ribbon cable from the module to the motherboard's SIR connector
according to the pin definitions. An optional consumer infrared (CIR) set con-
nects to the CIR and SIR connectors simultaneously for both wireless transmit-
ting and remote control functions through one external infrared module. Wake
On PS2 KB/Mouse in 4.5.1 Power Up Control must be Enabled in order to use
Consumer Infrared (CIR) power up.
CUWE-RM
®
CUWE-RM Infrared Module Connector
16) Serial Port COM 2 Header (10-1 pin COM2)
The optional serial port bracket can be used to add an additional serial port for
additional serial devices. The connector with bracket shown here is for the non-
LCD model.
CUWE-RM
®
CUWE-RM Serial Port Header
ASUS CUWE-RM User's Manual
IR_CON
Standard Infrared (SIR)
Front View
IRTX CIR+5V
CIRRX
GND
IRRX
GND
(NC)
+5V (NC)
COM2
Pin 1
Back View
+5V
IRTX
(NC)
GND
IRRX
37