Table of Contents
Advertisement
XDVD8130
Troubleshooting
Problem
Unit will not turn on
(no power)
Unit has power
(but no sound)
Unit blows fuse
Unit has audio
(but no video)
No subwoofer output or
low subwoofer output
No V3 video display
(when in reverse)
IR remote does not work
Excessive skipping
ERROR-01 appears
on display
ERROR-02 appears
on display
ERROR-03 appears
on display
Unit will not accept
a disc
Copyright Notes
This product incorporates copyright protection technology that is protected by method claims of
certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and
other rights owners. Use of this copyright protection technology must be authorized by Macrovision
Corporation, and is intended for home and other limited viewing uses only unless otherwise
authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are
trademarks of Dolby Laboratories.
Windows Media and the Windows logo are trademarks, or registered trademarks of Microsoft
Corporation in the United States and or other countries.
30
OPERATION
Cause
Yellow wire not connected or incorrect voltage
Red wire not connected or incorrect voltage
Black wire not connected
Fuse blown
Speaker wires not connected
One or more speaker wires touching each other
or touching chassis ground
Yellow or red wire touching chassis ground
Speaker wires touching chassis ground
Incorrect fuse rating
Parking brake safety circuit not connected
Parking brake not applied
Subwoofer mode is not active
Subwoofer output level is turned down
Reverse circuit not connected
Vehicle is not in reverse
Dead batteries
Remote set to control wrong model
Unit is not mounted correctly or backstrap is
not secure
Physical defect in media
Disc mechanism error
Focus error or disc is in upside down
Region code error
Disc mechanism position out of alignment
Disc mechanism transit screws still in place
Action
Check connections for proper voltage
(11~16VDC)
Check connection to ground
Replace fuse
Check connections at speakers
Insulate all bare speaker wires from each
other and chassis ground
Check for pinched wire
Check for pinched wire
Use fuse with correct rating
Check connections at parking brake
Apply parking brake
Activate subwoofer mode - see page 11
Increase subwoofer output level
Check connections at reverse lamp
Select reverse gear
Replace batteries
Select XDVD8130 - see page 9
Check mounting sleeve and backstrap
support
Check media for scratches
Press eject or RESET
Press eject or RESET
Use only DVDs labeled "Region 1" or
"All" only
Press EJECT for 3 seconds to reset
disc mechanism position
Remove 2 transit screws located on top
of the unit
Advertisement
Table of Contents
