Biostar M7VIZ Bios Setup Manual page 14

M7VIZ BIOS Setup
DRAM Timing
This item determines DRAM clock/ timing follow SPD or not.
The Choices: Auto By SPD (default), Manual, Turbo, Ultra.
DRAM CAS Latency
When DRAM is installed, the number of clock cycles of CAS latency depends on
the DRAM timing.
The Choices: 2.5 (default), 2.
Bank Interleave
This item allows you to enable or disable the bank interleave feature.
The Choices: Disabled (default), 2 bank, 4 bank.
Precharge to Active (Trp)
This items allows you to specify the delay from precharge command to activate
command.
The Choices: 2T, 3T, 4T, 5T (default).
Tras Non DDR 400/ DDR 400
This item allows you to choose Non DDR 400/ DDR 400
The Choices: 6T/ 8T, 7T/10T (default), 5T/ 6T, 8T, 12T.
Active to Precharge (Tras)
This items allows you to specify the minimum bank active time.
The Choices: 7T, 6T (default).
Active to CMD (Trcd)
Use this item to specify the delay from the activation of a bank to the time that a
read or write command is accepted.
The Choices: 2T, 3T, 4T, 5T (default).
DRAM Burst Length
The Choices: 4 (default), 8.
DRAM Queue Depth
This item permits to place the depths of the memory. The deeper the depth is,
the better is this function.
The Choices: 4 level (default), 2 level, 3 level.
DRAM Command Rate
This item controls clock cycle that must occur between the last valid write
operation and the next command.
The Choices: 1T Command, 2T Command (default).
Write Recovery Time
This item allows you to select the recovery time.
The Choices: 2T, 3T (default).
13