Integrated Peripherals - Gigabyte GA-78LMT-USB3 User Manual

& Full Screen LOGO Show
Allows you to determine whether to display the GIGABYTE Logo at system startup. Disabled displays
normal POST message. (Default: Enabled)
& Init Display First
Specifies the first initiation of the monitor display from the installed PCI graphics card, PCI Express graphics
card, or the onboard graphics.
PCI Slot Sets the PCI graphics card as the first display. (Default)
Sets the onboard graphics as the first display.
OnChipVGA
PEG Sets the PCI Express graphics card on the PCIEX16 slot as the first display.
2-6

Integrated Peripherals

CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
OnChip SATA Controller
OnChip SATA Type
x OnChip SATA Port4/5 Type
x OnChip SATA Port as ESP
Onboard LAN Function
Onboard LAN Boot ROM
` SMART LAN
Onboard Audio Function
F_USB30 Controller
R_USB30 Controller
USB Controllers
USB Legacy Function
USB Storage Function
Onboard Serial Port
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
: Move Enter: Select
F5: Previous Values
& OnChip SATA Controller
Enables or disables the integrated SATA controllers. (Default: Enabled)
& OnChip SATA Type (SATA2 0~SATA2 3 connectors)
Configures the operating mode of the integrated SATA controller.
Native IDE Allows the SATA controller to operate in Native IDE mode. Enable Native IDE mode if
you wish to install operating systems that support Native mode. (Default)
Enables RAID for the SATA controller.
RAID
AHCI C onfigures the SATA controllers to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
& OnChip SATA Port4/5 Type (SATA2 4/SATA2 5 connectors)
This option is configurable only when OnChip SATA Type is set to RAID or AHCI. Configures the operating
mode of the integrated SATA2 4/SATA2 5 connectors.
IDE D isables RAID for the SATA controller and configures the SATA controller to PATA mode.
(Default)
As SATA Type The mode depends on the OnChip SATA Type settings.
Integrated Peripherals
[Enabled]
[Native IDE]
IDE
Press Enter
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
3
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 32 -
Item Help
Menu Level `
ESC: Exit F1: General Help
F7: Optimized Defaults