Viewing A List Of Attached Devices; Upgrading The Router Firmware - NETGEAR WGT624v4 - 108 Mbps Wireless Firewall Router Reference Manual

108 mbps wireless router v4

Hide thumbs Also See for WGT624v4 - 108 Mbps Wireless Firewall Router:

Table of Contents

Viewing a List of Attached Devices

The Attached Devices page contains a table of all IP devices that the router has discovered on the

local network. From the main menu of the browser interface, under the Maintenance heading,

select Attached Devices to view the table shown below:

Figure 4-2

For each device, the table shows the IP address, NetBIOS host name (if available), and Ethernet

MAC address.

Note: Rebooting the router empties the table data until the router rediscovers the devices.

To force the router to look for attached devices, click Refresh.

The router firmware is stored in FLASH memory, and can be upgraded as new firmware is

released by NETGEAR. The upgrade process will typically take about one minute. Additionally,

some upgrades will require you to reset your router to its factory default settings.

Note: Be sure to check the NETGEAR website for documentation updates, which are

available at http://www.netgear.com/support.

To upgrade the router firmware:

1. Before you begin, make sure that you have:

•

A computer with a Web browser that supports HTTP uploads. For example, you can use

Microsoft Internet Explorer or Netscape Navigator 4.0 or later.

Maintenance

108 Mbps Wireless Router WGT624 v4 Reference Manual

v1.0, May 2007

4-3

Table of Contents