Asus A7V266 User Manual page 37

3. HARDWARE SETUP
13) Infrared Module Connector (10-1 pin IR_CON)
This connector supports an optional wireless transmitting and receiving infrared
module. This module mounts to a small opening on system cases that support
this feature. You must also configure the setting through UART2 Use Infrared
(see 4.4.2 I/O Device Configuration) to select whether UART2 is directed for
use with COM2 or IrDA. Use the five pins as shown in Back View and connect
a ribbon cable from the module to the motherboard SIR connector according to
the pin definitions. (NOTE: The SIR module does not come with the motherboard
package. The CIR module is currently not available.)
1 0 1 0 1 0
A7V266
A7V266 Infrared
Module Connector
14) ASUS iPanel Connector (24-1 pin AFPANEL)
This connector allows you to install an optional ASUS iPanel, an easy to access
drive bay with front I/O ports, status LEDs, and space reserved for a hard disk
drive. If you are not using an ASUS iPanel, you can connect an optional wireless
transmitting and receiving infrared module to the SIR connector or an optional
consumer infrared connector set to the CIR and SIR connectors for both wireless
transmitting and remote control functions through one external infrared module.
1 0 1 0 1 0
A7V266
A7V266 Front Panel Connectors
AFPANEL
SIR
CIR
IR_CON
ASUS A7V266 User's Manual
Standard Infrared (SIR)
Front View Back View
SIR
CIR
IRTX
GND
IRRX
Standard Infrared (SIR)
Front View Back View
IRTX
GND
IRRX
+5V
(NC)
+5V
(NC)
37