Troubleshooting With The Leds; Power/Test Led Is Off Or Blinking; Power/Test Led Stays Amber - NETGEAR R6300 User Manual

Troubleshooting with the LEDs

After you turn on power to the router, the following sequence of events should occur:
When power is first applied, verify that the Power/Test LED
1.
Verify that the Power/Test LED turns amber within a few seconds, indicating that the self-test
2.
is running.
After approximately 30 seconds, verify the following:
3.
The Power/Test LED is solid green.
•
The Internet LED is on.
•
A numbered Ethernet port LED is on for any local port that is connected to a
•
computer. This indicates that a link has been established to the connected device.
The LEDs on the front panel of the router can be used for troubleshooting.

Power/Test LED Is Off or Blinking

Make sure that the power cord is securely connected to your router and that the power
•
adapter is securely connected to a functioning power outlet.
Check that you are using the 12V DC, 5A power adapter that NETGEAR supplied for this
•
product.
If the Power/Test LED blinks slowly and continuously, the router firmware is corrupted.
•
This can happen if a firmware upgrade is interrupted, or if the router detects a problem
with the firmware. If the error persists, you have a hardware problem. For recovery
instructions, or help with a hardware problem, contact technical support at
www.netgear.com/support.

Power/Test LED Stays Amber

When the router is turned on, the Power/Test LED turns amber for about 20 seconds and
then turns green. If the LED does not turn green, the router has a problem.
If the Power/Test LED is still amber 1 minute after you turn on power to the router:
Turn the power off and back on to see if the router recovers.
1.
Press and hold the Reset button to return the router to its factory settings. as explained
2.
in
Restore the Factory Settings and Password
If the error persists, you might have a hardware problem and should contact technical support
at
www.netgear.com/support.
R6300 WiFi Router 802.11ac Dual Band Gigabit
Troubleshooting
108
is on.
on page 113.