NETGEAR R6300 User Manual page 100


To set up a static route:
Select Advanced > Advanced Setup > Static Routes, and click Add to display the
1.
following screen:
In the Route Name field, type a name for this static route (for identification purposes only.)
2.
Select the Private check box if you want to limit access to the LAN only. If Private is
3.
selected, the static route is not reported in RIP.
Select the Active check box to make this route effective.
4.
Type the destination IP address of the final destination.
5.
Type the IP subnet mask for this destination. If the destination is a single host, type
6.
255.255.255.255.
Type the gateway IP address, which has to be a router on the same LAN segment as the
7.
R6300 WiFi Router.
Type a number from 1 through 15 as the metric value.
8.
This value represents the number of routers between your network and the destination.
Usually, a setting of 2 or 3 works, but if this is a direct connection, set it to 1.
Click Apply to add the static route.
9.
R6300 WiFi Router 802.11ac Dual Band Gigabit
Advanced Settings
100