Toro 38360 - Power Shovel 7.5 Amp Snow Thrower/Electric Broom Operator's Manual page 5

Converting from
Snowthrowing to Sweeping
Important: Disconnect the power from the Power
Shovel Plus before performing this procedure.
1. Remove the
bolt on the side of
the housing.
2. Remove the
snowthrower rotor
from the housing.
3. Install the
broom in the
housing.
4. Secure the
broom with the bolt
that you previously
removed.
m-7389
5. Tighten the
bolt on the side of
the housing.
6. Install the
deflector.
Note: The
deflector snaps
into place.
m-7386
7. Loosen the
lower knob on the
shaft.
8. Rotate the
handle grip to the
opposite side of
the shaft.
m–7397
9. Tighten the
knob.
10. Ensure that the
Power Shovel Plus
is in the broom
mode as shown.
m-7388
Note: You may need to adjust the length of the shaft
to comfortably operate in broom mode. Refer to
m-7386 Adjusting the Power Shovel Plus Height on page 3.
5
m–7694
m–7693
m-7385
m–7692