System Check Mode - Samsung DV363EWBEUF/A1 Technical Information

ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before
servicing, unless testing requires power.
Temperature Display Mode(in Celsius)
Definition of Temperature Display Mode:
- With power on, Press Sinal and Wrinkle Prevent keys simultanously for 3 seconds.
-
This action will put the dryer into Touch Sensor Mode
-
Under "Touch Sensor Mode", Press Time and Wrinkle Prevent Keys at the same time.
-
Then the dryer will display the temperature of drum inside in Celsius.
How to Enter:
- Under normal User Mode, Press "Signal and Wrinkle Prevent" Keys simultanously for 3 seconds
- Then press "Time and Wrinkle Prevent" keys at the same time.
• Converting °C  °F
Celsius(°C)
Fahrenheit(°F)
Software Version Mode
Definition of Software Version Mode:
-
While in Service Mode pressing the Temp key will put the dryer into the software version
mode
How to Enter:
- To enter Special Test Mode press Temp Key until the control beep.
ex) In case of "U1 05", U1 means major version "U1", 05 means minor version "05".

System Check Mode

Special Test Mode:
-
While in Power Off, pressing the Dryness Level + Power keys simultaneously will put the dryer
into the System Check mode
-
" t2 " will display.
-
System Check Mode Progress t2 mode Function Performed Start/Pause
Motor(CW) Relay On  Heater Relay On  Heater Relay Off  Motor(CW) Relay Off
(Circulation)
Technical_information-02365J_EN.indd 4
WARNING
-30 -10 10
-22 14 50
30 50
86 122
4
70
F =9/5C + 32
158
2012-06-05 5:08:13