GE GFMN100ELWW Use And Care Manual page 31

REMOVE DOOR ASSEMBLY (cont.)
2
Lay the door down on a soft protected flat surface so that
the inner part faces upward (door resting on the handle
side).
Remove the 6 large tapping screws (#10) located around
the perimeter of the door outlining the gasket, and the 2
machine screws (#8) on the hinge side.
2 #8 Machine
Screws
With the screws removed, turn the door over and
separate the silver cover part of the door from the door
frame and set aside.
Unlock the 4 tabs on the plastic cover and separate the
plastic cover from the frame.
NOTE: Disregard the "DO NOT REMOVE" label on the
plastic cover.
6 #10 Large
Screws
2 #8 Machine
Screws
REMOVE HINGE
3
IMPORTANT: Note the location of the hinge (left or right)
before removing.
With the door frame part of the door laid down on
a protected soft surface, remove the hinge cover by
removing the 2 tapping screws (#8) that fasten it to the
frame. The hinge cover is located at the opposite side of
the hinge assembly.
Remove the 2 nuts, washers and the 2 machine screws (#8).
Remove the hinge assembly by removing the 2 machine
screws (#8) that fasten it to the frame. Pull the hinge
assembly out and set it aside.
www.GEAppliances.ca
31