Draytek VigorPro 5500 Series User Manual page 137

The Virtual TA client only supports the CAPI 2.0 protocol and has no built-in FAX
engine.
One ISDN BRI interface has two B channels. The maximum number of active clients is
also 2.
Before you configure the Virtual TA, you must set the correct country code in ISDN
Setup.
Virtual TA Server
Virtual TA User Profiles
I n s t a l l
I n s t a l l
1. Insert the CD-ROM bundled with your Vigor router. Find VTA Client tool in the
Utility menu and click on the Install button.
2. Follow the on-screen instructions of the installer. The last step will ask you to restart
your computer. Click OK to restart your computer.
3. After the computer restarts, you will see a VT icon in the taskbar (usually in the
bottom-right of the screen, near the clock) as shown below.
When the icon text is GREEN, the Virtual TA client is connected to the Virtual TA server and
you can launch your CAPI-based software to use the client to access the router. If the icon
text is RED, it means the client has lost the connection to the server. This time, please check
the physical Ethernet connection.
VigorPro5500 Series User's Guide
Enable - Select it to activate the server.
Disable - Select it to deactivate the server. All Virtual TA
applications will be terminated.
Username - Enter the username of a specific client.
Password - Enter the password of a specific client.
MSN 1/2/3 - MSN stands for Multiple Subscriber Number. It
means you can apply to more than one ISDN lines number over
a single subscribed line. Note that the service must be acquired
from your telecom. Specify the MSN numbers for a specific
client. If you have no MSN services, leave this field blank.
Active - Check it to enable the client to access the server.
a V i r t u a l T A C l i e n
a V i r t u a l T A C l i e n
t
t
129