Table of Contents
Advertisement
4. Choose the RUN option from the menu.
5. Follow the installation directions on the screen. The FPR-100/10 must be
installed in the "C:\Fpr100\" directory. This directory is already set when you
run the setup program.
6. Please refer to section 4.1 to set up your printer for use with the system.
4.1
Adding a Printer
1. Click the START button on the bottom of your Windows operating system.
2. Click the Settings option on the pop up menu.
3. Click the Printers option on the Settings menu.
4. From the Printers box that appears, click Add Printer and follow the
instructions. If you are using a computer purchased from ACR Electronics and
you are asked for the Windows disk, do the following:
A. When you get the message "Please insert the disk labeled ' Windows 95
CD-ROM' and then click OK" click the OK button.
B. There will then be an input box with the title Copying Files... In the space
provided
C:\Windows\Options\cabs then press ENTER.
C. If this does not work or if the computer cannot identify your printer, contact
the printer manufacturer for more information.
5. The printer, set up as your default printer, will be used by the FPR-10 for
printing labels and reports.
5.0
USING THE FPR-10
5.1
Programming the Message
The FPR-10 can program the Satellite
GlobalFix 406 RLB-35 and the GyPSI 406 PLB-100.
accomplished by generating the message in the computer with information based
on the unit and protocol selected. Data is then sent to the FPR-10 interface unit and
the interface unit handles all further communications with the beacons via infrared
light.
To program an RLB-32, RLB-33 or PLB, connect 6 Conductor Cable with RJ11
(phone) between the front panel of the FPR-10 and the appropriate programming
head. Perform the following steps:
1. From the Product Selection Menu, click the button for the product you wish to
program.
under
the
Copy
4
files
from:
type
406 RLB-32
RapidFix 406 RLB-33,
2
,
the
following:
Programming is
Y1-03-0164 Rev. A
Advertisement
Table of Contents
