Door Panel - Dometic RM2301 Installation And Operating Instructions Manual

INSTRUCTIONS FOR MOUNTING THE DOOR PANEL
INSTRUCTIONS FOR MOUNTING
THE DOOR PANEL
The refrigerator is normally delivered without door
panel(s). Before starting the mounting work check that
the panel dimensions are in compliance with those
given in the table and read the instructions through.
When mounting the panel, proceed as follows.
A. Remove the door decoration list (2) with its two
screws (1 j.The upper corners of the upper panel
(2-door models) and the lower corners of the lo-
wer panel has to be cut according to the sketch.
B. Insert one of the vertical edges of the panel into
the groove of the door frame (3).
C. Bend the panel gently so that the free side of the
panel can be sled into the corresponding groove
of the door frame (4).
D. Push the panel downwards so that the lower ho-
rizontal edge of the panel is fitted into the bottom
groove (5).
E. Between the upper edge of the panel and the
door frame there is now a gap which should be
covered by the decoration strip.
F. Put the strip across the door so that the gap is
covered and pushed upwards (6). The tabs on
the inside of the strip should fit in behind the
flange of the door frame. Secure the decoration
strip by means of the two screws (1).
Panel dimensions
Thickness max. 4 mm 5/32 inches
HEIGHT
MAX.
R M 2 3 0 1 m m
inch
R M 2 4 0 1 m m
inch
RM2501 m m
inch
upper mm
RM2601 inch
lower mm
inch 32 29/32 32 27/3
upper
mm 395
RM2801
inch 15 17/3
lower
mm 914
inch 35 31/3
TO CHANGE THE DOOR OPENING FROM
LEFT TO RIGHT OR VICE VERSA
Open the door and unscrew the two screws holding the top
front cover. The screws are accessible from beneath.
Remove the top hinge pin and lift out the door. The lower
pin for the refrigerator door should be shifted to the oppo-
site side.
The door can then be remounted. But before the front
decoration check that the door closes well and the latch
works properly. If not, correct the door by loosen the two
screws for the upper hinge against the front frame and
adjust. Then tighten the screws and replace the front
decoration.
door
Lower
Unscrew the hinge pin from the lower doors upper hinge.
Lift the door from the bottom hinge pin and move the pin to
opposite side. Replace the door and correct the doors lock-
ing position by means of the washers, if necessary adjust
also the bottom hinge in the same way as the upper door.
WIDTH
MIN. MAX. MIN.
568
22 3 / 8
568
22 3/8
393 618
616
15 15/32 24 5/16
24 1/4
912 618 616
35 29/32 24 5/16 24 1/4
AB-FPB 8717 cap 820 4552-00/7