Table of Contents
Advertisement
Quick Links
Minoura Japan Headquarters
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone: +81-584-27-3131 / Fax: +81-584-27-7505
Email: minoura@minoura.jp / URL: www.minoura.jp
INDOOR BICYCLE TRAINER
Made in Japan
Minoura North American Center
(for U.S. residents only)
1996 East Avenue, Hayward, CA 94541-5454 U.S.A.
Phone: 1-510-538-8599 / Fax: 1-510-538-5899
Email: support@minourausa.com
Advertisement
Table of Contents
Related Manuals for MINOURA VFSG-9
Summary of Contents for MINOURA VFSG-9
- Page 1 Minoura North American Center 1197-1 Godo, Anpachi, Gifu 503-2305 Japan (for U.S. residents only) Phone: +81-584-27-3131 / Fax: +81-584-27-7505 1996 East Avenue, Hayward, CA 94541-5454 U.S.A. Email: minoura@minoura.jp / URL: www.minoura.jp Phone: 1-510-538-8599 / Fax: 1-510-538-5899 Email: support@minourausa.com Made in Japan...
- Page 2 If your bicycle has a fixed axle nut system you cannot use the supplied q/r and must make sure that the axle nuts fits securely into the couplings. If they do not fit evenly and securely, our trainer is not compatible with your bicycle and Minoura assumes no responsibility for such use.
- Page 3 VFS-G (without remote shifter) Magnet Inner Housing Fluid Unit Flywheel Cover Flywheel Alloy Rotor Remote Shifter Remote Cable Magnet Inner Housing Remote Cover Spring Fluid Unit Remote Ring Remote Bracket Outer Housing Coupling Cover Coupling Tube (L) Coupling Cover Coupling Tube (R) Hub Knob Bolt Protector Cap...
- Page 4 ASSEMBLE YOUR VFS-G TRAINER Assemble the Sub Frame onto the Main Frame: The metal Sub Frame Back Plate must be placed on the bottom of the Sub Frame as M8x20 Bolt shown in Fig. A. Insert the M8 Nylon Nut into the hole on the backside of the Sub Frame.
- Page 5 You can adjust the resistance unit position in 4 patterns to get the best tire contact to the drive roller for maximum performance. Wrong positioning may cause damage to the bearing and the unit housings. The best hole combination can be seen M8 Washer on the below matrix and Fig.
- Page 6 PIVOT CAUTION The pivot between the Main Frame and the Sub Frame should be tightened firmly for easier installation of your bike onto VFS-G. The 6mm Hex Wrench is located in the L-shaped groove on the Sub Frame. Use this tool to tighten the pivot bolts. CAUTION: To much tightening may break the Sub Frame.
- Page 7 Put the left end of the quick release skewer (lever side), or axle nut, into the left side coupling. Now, adjust the coupling angle so that the large cutout clamps and lever are adjusted for easier fitting. Turn the Hub Handle in a counter- clockwise direction to close the coupling.
- Page 8 The tire must be positioned in the center area of the drive roller (see Fig. L). If the tire is in contact or touching the other part of the resistance unit rather than the drive roller (see Fig. M), adjust the wheel position with the following steps; 1.