Important Notice - MINOURA M70-R Instruction Manual

IMPORTANT NOTICE

• For use with a normal 2-wheel bicycle only. Do not use a tandem, recumbent, or other.
• Hub nut type rear wheel axle is not compatible with M70-R/M80-R in standard.
You need to replace the left side coupling (UF-8) with optional "Left Side Coupling for
Hub Nut Axle".
• Fits tire size between 20x1-3/8" and 29x2.10". To use 26x1.00" or smaller tire, install
the supplied Small Wheel Adaptor.
• Some assembly required. Use correct tools (10mm spanner & M4 hex wrench).
Tools are not supplied in the kit.
• Use the supplied rear quick release skewer for maximum stability.
Minoura is not responsible for any problem caused from using your own skewer.
• Use on flat and level floor or ground for your safety.
• Adjust the roller pressure to the rear tire properly in order to maximize your tire life.
Tire and roller contact will eventually wear both your tire and the trainer roller.
• Check and adjust the remote shifter cable tension when you cannot set at L or H even
though you turn the shifter lever.
• Touching the spinning wheel and/or any other moving parts while training may cause
serious injury. Keep children and pets away from the trainer when in use.
• It is not possible to convert the remote controllable resistance unit to the non-remote
version one due to a difference in the inside mechanism.
• If you feel any strange noise or smell, stop using M70-R/M80-R immediately and
contact the retailer where you purchased the M70-R/M80-R.
• Any warranty will be void if you use M70-R/M80-R for other purpose than instructed.
Minorua offers 1-year limited warranty on the resistance unit and 5-year limited
warranty on the frame from the date of your purchase for any problem caused by
manufacturer's defect.
Any damage or problem caused by transporting process is not covered under warranty.
Any damage from shipping or moving must be made to the shipping company.
Read enclosed "Minoura Limited Warranty Policy" card for more detail.
- Page 2 -