Advertisement
!
If the red Warning Sign is visible below the Upper Rubber Cup even after following
the above instructions, the pole extension is too short and may cause the bikes to
fall over.
Please start the installation process over again to insure proper set up and that the
red Warning Sign does not appear.
!
Make sure the BIKE TOWER is set up vertically
with no slant. Failure to do so may cause
equipment or personal damage.
The Bike Cradle is angle adjustable. If you
5
want to move the cradle, loosen the lower
bolt on the Angle Adjust Plate, change
the angle until the displayed bike will be
horizontally as much as possible, then
tighten the bolt firmly again.
(see Fig. H & I)
Why My Nut Is Misaligned?
The inside nut of the stainless band is not square, it is rectangle. You have to remove the stainless band to wind up it
around the pole for assembling. At this time, do NOT remove the nut from the band.
If you had removed the nut, make sure the nut direction that the longer side must be vertical.
If you see there is some space between the nut and the stainless band, the direction is wrong.
Usual Check List
You must check the following points everytime before use;
1. Check there are no cracks in the Main Pole and the Pole Joint.
2. Check all fittings are securely fastened.
3. Check to make sure the Main Pole is not bent or developing any rust.
For More Information...
MINOURA Japan Headquarters
(for ALL customers)
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Email: minoura@minoura.jp
www.minoura.jp
Made in Japan
Safe bike hooking position
Long
Short
MINOURA North America
(for U.S. residents only)
1996 East Ave, Hayward, CA 94541 U.S.A.
Phone: 510-538-8599 / Fax: 510-538-5899
Email: support@minourausa.com
- Page 4 -
Metal Band
Nut
(Fig. H)
(Fig. I)
Plastic
Cover
Advertisement
