Recording Back To An Hdv Camcorder - Ulead VIDEOSTUDIO 11 User Manual

126
ULEAD VIDEOSTUDIO USER GUIDE
6. In the Project Playback - Record Window dialog box, use the Navigation
Panel to go to the section of the DV tape where to start recording.
Tip: Click Transmit to device unit for preview to preview your project on the DV
camcorder's LCD monitor.
7. Click Record. After you are done recording your project to the DV camcorder,
click Finish.
Note: Before recording a video file back to your DV camcorder, make sure the video is
saved with the correct codec. For example, the codec DV Video Encoder usually works
well for most NTSC DV camcorders. You can select it from the Compression tab in the
Video Save Options dialog box.

Recording back to an HDV camcorder

To record your finished project to an HDV/HD camcorder, you must first render it as
HDV/HD-encoded MPEG-2 transport stream file.
To record a movie to your HDV camcorder:
1. Turn your camcorder on and set it to Play/Edit mode. See your camcorder's
manual for specific instructions.
2. In Share Step Options Panel, click HDV Recording and select a transport
stream template.
3. Enter a file name in Create Video File dialog box.
4. VideoStudio renders the project. When done, HDV Recording - Preview
Window dialog box opens. You can preview the video file here.
5. Click Next to start recording.
6. In the Project Playback - Record Window dialog box, use the Navigation
Panel to go to the section of the DV tape where to start recording.
Tip: Click Transmit to device unit for preview to preview your project on the DV
camcorder's LCD monitor.
7. Click Record. After you are done recording your project to the DV camcorder,
click Finish.