Table of Contents
Advertisement
114 ULEAD PHOTOIMPACT USER GUIDE
4. Click to mark the starting point then trace the subject you want to select by
moving the mouse over the edges of the subject (no need to hold down mouse
button).
5. While tracing, when you have made a desired edge selection, click on the
selection path to add an anchor point. Adding an anchor point prevents you
from accidentally retracing (deleting) your selection path.
Tips:
• If you make a mistake in selecting, just retrace along the selection path to the
point where you want to begin selecting again. You cannot retrace a path that is
in between two anchor points.
• To delete a selection path that is between two anchor points, press
[Backspace].
6. Click on the starting anchor point to close the selection. The selection path,
instead of the usual dotted path, becomes a line path.
Tip: You can also double-click to close the selection.
To use the Lasso Tool (no Smart lasso):
1. Drag the mouse to select the subject.
Tip: If you are selecting a straight edge, release the mouse when you reach the
starting point of the straight line then click the end of the straight line.
2. Follow steps 6 of the "To use the Lasso Tool (Smart lasso)" procedure.
Tip: To add to an existing selection, press [A] as you select. To remove parts of a
selection, press [S] as you define the section to remove.
Flower selected and moved.
Advertisement
Table of Contents
