Table of Contents
Advertisement
224 ULEAD PHOTOIMPACT USER GUIDE
Note: Available settings depend on the chosen pattern. For instance, when selecting
Line, you can only adjust the Line angle, Density, and Max. thickness.
4. Determine the Threshold range for the current layer. This is the tonal range
(from 0 to 255) from the source image where the effect will be applied. The
following is the default range that is chosen for each layer:
• Bottom Layer The full tonal range is selected to cover the whole source
image in the effect.
• Middle Layer All the shadows and a substantial part of the highlights and
midtones are covered.
• Top Layer Only the shadows are covered.
Adjust the threshold range to fine tune the depth of the effect.
5. For each layer, you can also adjust the Brightness and Contrast of the areas
that are applied with the engraving effect.
6. For the resulting image, choose a color for the engraving. You can use a solid
color or the colors from the source image. (Usually, the standard color is black).
You can also set the color for the canvas (that is, the non-engraved areas).
7. Click OK.
Original image
Bottom and Middle Layers enabled
Only Bottom Layer enabled
Bottom, Middle and Top Layers enabled
Advertisement
Table of Contents
