Compaq 1700 - Armada - PII 266 MHz Installation Manual page 11

Installing Microsoft Windows NT Workstation 4.0 on Compaq Armada Products
Installing Service Pack 3 from CD
1. Log on to the system as Administrator.
2. Click OK to close the Tip window.
3. Insert the Windows NTW Service Pack 3 CD into the CD-ROM drive. Internet Explorer starts
automatically and displays the initial installation screen.
4. Click 'Install Service Pack 3 for Windows NT 4.0' to start the installation. A Confirm File Open dialog
box appears.
5. Choose OPEN to continue.
6. Click Next from the Welcome screen.
7. Read the Software License Agreement and click Yes to accept the terms.
8. Click Next to install the Service Pack from the Service Pack Setup screen.
9. It is highly recommended that you choose to create an Uninstall Directory. Make the appropriate
choice and click Next to continue.
10. Click Finish to install Service Pack 3 and wait while the files are copied from the CD to the hard drive.
11. Read the 'Windows NT Service Pack Setup' screen then click OK.
12. The system reboots.
NOTE: If at anytime, you change the configuration of your system including adding or
removing any NTW components, you must reapply the Service Pack and the Windows NTW 4.0
Support Diskette (installed in the Installation of Compaq Drivers and Enhancements section).
You should also update the Emergency Repair disk after ensuring the configuration is correct.
Document number PRT009A1098
11