System Status Reports - ADEMCO 4286 - Phone Module User Manual

A System status report is provided automatically following phone
access to the system. System status is also reported through an
optional warning speaker by pressing
security keypad(s). The system status report includes the following:
Alarm warning sounds (if any). Not provided in some systems.
Fire alarms (if any).
Burglary and other alarms (if any).
Checks (if any).
Power status (an AC power loss or low battery condition exists).
Arming status (plus Bypasses, if any).
Remote access (only when Off).
Chime sounds (if chime mode is on and door or window is opened).
Not provided in some systems.
Zone faults (if any). If not annunciated in your system, press
key to hear zones that are faulted.
Note: Silent (panic) alarms will be annunciated as faults.
There is a 1-second pause between each individual status report. A
system command may be entered during these pauses, or immediately
following the end of the report.
Alarm Warning Sounds
If a Fire or Burglary alarm is in progress (or in alarm memory), the
status report will commence with a short burst of either a Fire alarm
sound ("bell" sound), or Burglary sound (2-tone siren sound).
Note: Alarm warning sounds may not be provided over the
phone with your particular system.
Fire Alarm
The word "FIRE" will then be annunciated, followed by a zone
description* (for instance, "UPSTAIRS BEDROOM") and a 2-digit
zone number (zones below 10 will be annunciated with a leading zero).
* If programmed by your installer.

System Status Reports

on the installer designated
15