Pci Configuration Status And Error Messages - Sony PCV-J200 - Vaio Desktop Computer System Reference Manual

76
VAIO® System Reference Manual

PCI Configuration Status and Error Messages

The following is a list of status and error messages that may appear on
your system.
Message
Floppy Disk Controller
Resource Conflict
CMOS Checksum Error,
CMOS Cleared
CMOS Data Invalid,
CMOS Cleared
Parallel Port Resource
Conflict
PCI Error Log is Full
PCI I/O Port Conflict
PCI IRQ Conflict
PCI Memory Conflict
Primary Boot Device Not
Found
Primary IDE Controller
Resource Conflict
Primary Input Device Not
Found
Primary Output Device
Not Found
Secondary IDE Controller
Resource Conflict
Serial Port 1 Resource
Conflict
Static Device Resource
Conflict
System Board Device
Resource Conflict
Meaning
The floppy disk controller has requested a
resource that is already in use.
The CMOS data was reinitialized due to a
CMOS checksum error.
Invalid entry in the CMOS.
The parallel port has requested a resource that is
already in use.
This message is displayed when more than 15
PCI conflict errors are detected. No additional
PCI errors can be logged.
Two devices requested the same resource,
resulting in a conflict.
Two devices requested the same resource,
resulting in a conflict.
Two devices requested the same resource,
resulting in a conflict.
The designated primary boot device (hard disk
drive, floppy disk drive, CD-ROM drive, or
network drive) could not be found.
The primary IDE controller has requested a
resource that is already in use.
The designated primary input device
(keyboard, mouse, or other, if input is
redirected) could not be found.
The designated primary output device (display,
serial port, or other, if input is redirected) could
not be found.
The secondary IDE controller has requested a
resource that is already in use.
Serial port 1 has requested a resource that is
already in use.
A device has requested a resource that is already
in use.
A device has requested a resource that is already
in use.