Dodge 2010 Nitro Owner's Manual page 195

194 UNDERSTANDING YOUR INSTRUMENT PANEL
normal, turn the engine off immediately and call for
service. Refer to "If Your Engine Overheats" in "What To
Do In Emergencies" for further information.
7. Speedometer
Shows the vehicles speed.
8. High Beam Indicator
This indicator shows that the high beam head-
lights are on. Push the multifunction lever forward
to switch the headlights to high beam, and pull toward
yourself (normal position) to return to low beam.
9. Vehicle Security Light — If Equipped
This light will flash at a fast rate for approxi-
mately 15 seconds, when the vehicle security
alarm is arming, and then will flash slowly
until the vehicle is disarmed.
10. Electronic Stability Program (ESP) Warning Light /
Brake Assist System (BAS) Warning Light – If
Equipped
The malfunction light for the Electronic Stabil-
ity Program (ESP) is combined with Brake
Assist System (BAS). The yellow "ESP/BAS
Warning Light" comes on when the ignition
switch is turned to the "ON" position. They should go
out with the engine running. If the "ESP/BAS Warning
Light" comes on continuously with the engine running, a
malfunction has been detected in either the ESP or the
BAS system. If this light remains on after several ignition
cycles, and the vehicle has been driven several miles
(kilometers) at speeds greater than 30 mph (48 km/h), see
an authorized dealer as soon as possible.
NOTE: The ESP Control System will make buzzing or
clicking sounds when it is actively operating.