Features And Specifications - IBM 8836 - Eserver xSeries 306 Installation Manual

Features and specifications

The following information is a summary of the features and specifications of your
server. Depending on your server model, some features might not be available, or
some specifications might not apply.
Racks are marked in vertical increments of 1.75 inches. Each increment is referred
to as a unit, or "U." A 1-U-high device is 1.75 inches tall.
Table 1. Features and specifications
Microprocessor:
One Intel Pentium IV 1024 KB
(minimum) Level-2 cache and MMX
(MMX2) technology
Note: Use the Configuration/Setup
Utility program to determine the type
and speed of the microprocessor in
your server.
Memory:
v Minimum: 512 MB
v Maximum: 4 GB
v Type: PC2700/3200,
333/400 MHz, ECC, SDRAM,
registered DIMMs only
v Slots: Four dual inline
v Supports 256 MB, 512 MB, and
1 GB DIMMs
Drives:
v Diskette: 1.44 MB
v CD-ROM: IDE
Expansion bays:
Two 3.5-inch slim-high bays for hard
disk drives
Expansion slots:
Two 66 MHz/64-bit PCI-X slots (one
low profile half-length, one full-height
three-quarter-length)
Video controller:
v ATI Radeon 7000M IGP video on
system board
v Compatible with SVGA and VGA
v 16 MB DDR-SDRAM video memory
Power supply:
300 watt (110 or 220 V ac
auto-sensing)
4
IBM xSeries 306 Type 8836: Installation Guide
Size:
v Height: 43 mm (1.75 inches, 1 U)
v Depth: 508 mm (20 inches)
™
v Width: 430 mm (16.69 inches)
v Maximum weight: 12.7 kg (28 lb)
depending on your configuration
Integrated functions:
v Dual 1000Base-T, 100Base-T,
10Base-T Ethernet controllers on
the system board with Wake on
®
LAN support
v Serial port
v Four USB ports (two on front and
two on rear of server)
v Keyboard port
v Mouse port
v ATA-100 single-channel IDE
controller
Hard disk controllers:
v Serial ATA controller with
integrated RAID
v Ultra320 SCSI controller with
integrated RAID (SCSI models)
Acoustical noise emissions:
v Sound power, idling: 6.5 bel
maximum
v Sound power, operating: 6.5 bel
maximum
Environment:
v Air temperature:
– Server on: 10° to 35°C (50.0°
to 95.0°F); altitude: 0 to 914 m
(2998.7 ft)
– Server off: -40° to 60°C
(-104° to 140°F); maximum
altitude: 2133 m (6998.0 ft)
v Humidity:
– Server on: 8% to 80%
– Server off: 8% to 80%
Heat output:
Approximate heat output in British
thermal units (Btu) per hour:
v Minimum configuration: 307 Btu (90
watts)
v Maximum configuration: 850 Btu
(250 watts)
Electrical input:
v Sine-wave input (47-63 Hz) required
v Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v Input kilovolt-amperes (kVA),
approximately:
– Minimum: 0.20 kVA
– Maximum: 0.45 kVA
Notes:
1. Power consumption and heat
output vary depending on the
number and type of optional
features installed and the
power-management optional
features in use.
2. These levels were measured in
controlled acoustical environments
according to the procedures
specified by the American National
Standards Institute (ANSI) S12.10
and ISO 7779 and are reported in
accordance with ISO 9296. Actual
sound-pressure levels in a given
location might exceed the average
values stated because of room
reflections and other nearby noise
sources. The declared sound-power
levels indicate an upper limit, below
which a large number of computers
will operate.