Installing The Cooktop - GE PP989DNBB - Profile 30" Smoothtop Electric Downdraft Cooktop Use And Care Manual

INsTAllING The CookToP
9
Lift the cooktop by the glass side edges as shown .
NoTe: Do not use the glass top vent opening to lift
or move the cooktop into position .
Lower the cooktop into the countertop opening,
guiding it into position . Glass is fragile—do not allow
it to drop onto the countertop . Support from the
underside and lower slowly .
Carefully remove your fingers one corner at a time
to lower the cooktop into position .
NoTe: Do not use Silicone RTV or caulk to bond
cooktop glass to countertop .
Installation Instructions
INsTAllING The CookToP
C AuTIoN:
Do NoT lIfT
fRom VeNT
oPeNING.
22
CheCkING foR flATNess
10
Inspect the cooktop glass for rocking or uneven
gap on all four sides at the countertop surface .
Do not attempt to force the glass to meet
the countertop .
INsTAllING The oPTIoNAl
11
INsTAllATIoN BRACkeTs
NoTe: Check for glass flatness in Step 10 before
installing optional installation brackets .
Cooktop
Screws supplied
with cooktop
To order optional installation brackets/thumbscrews,
call the National Parts Center at 800 . 6 26 . 2 002 .
Order two of each part: WB02X11331 Bracket
To install optional installation brackets:
Remove 2 screws on both sides under cooktop .
Align optional installation bracket under cooktop
and reinstall screws through the slot in the bracket .
Do this on both sides of the cooktop .
Thread the thumbscrew through the hole
in the bracket and tighten to secure the cooktop
to the countertop . Repeat on the other side .
ImPoRTANT: Turn thumbscrew until it touches
the bottom of the countertop . Do not overtighten .
Check for
uneven gaps
Optional installation
bracket and
thumbscrew (not
included)
Countertop
Thumbscrew
WB01X10353 Screw