Table of Contents
Advertisement
Precautions
CAUTION
HAVE THE WIRING AND INSTALLATION DONE
BY EXPERTS.
The wiring and installation of this unit requires
special technical skill and experience. To ensure
safety, always contact the dealer where you
purchased this product to have the work done.
USE SPECIFIED ACCESSORY PARTS AND
INSTALL THEM SECURELY.
Be sure to use only the specified accessory parts.
Use of other than designated parts may damage this
unit internally or may not securely install the unit in
place. This may cause parts to become loose
resulting in hazards or product failure.
ARRANGE THE WIRING SO IT IS NOT CRIMPED
OR PINCHED BY A SHARP METAL EDGE.
Route the cables and wiring away from moving parts
(like the seat rails) or sharp or pointed edges. This
will prevent crimping and damage to the wiring. If
wiring passes through a hole in metal, use a rubber
grommet to prevent the wire's insulation from being
cut by the metal edge of the hole.
DO NOT INSTALL IN LOCATIONS WITH HIGH
MOISTURE OR DUST.
Avoid installing the unit in locations with high
incidence of moisture or dust. Moisture or dust that
penetrates into this unit may result in product failure.
Installation and Connections
Precautions
• Be sure to disconnect the cable from the (–)
battery post before installing your KCE-425i. This
will reduce any chance of damage to the unit in case
of a short-circuit.
• Be sure to connect the colour coded leads
according to the diagram. Incorrect connections
may cause the unit to malfunction or damage to the
vehicle's electrical system.
• When making connections to the vehicle's
electrical system, be aware of the factory installed
components (e.g. on-board computer). Do not tap
into these leads to provide power for this unit. When
connecting the KCE-425i to the fuse box, make sure
the fuse for the intended circuit of the KCE-425i has
the appropriate amperage. Failure to do so may
result in damage to the unit and/or the vehicle.
When in doubt, consult your ALPINE dealer.
EN
23
Advertisement
Table of Contents
