Yamaha RXV363BL Owner's Manual page 25

4
Press J l / h to select "AUTO".
Choices: AUTO, RELOAD, UNDO, DEFAULT
• Select "AUTO" to automatically run the entire
"AUTO SETUP" procedure.
• Select "RELOAD" to reload the last "AUTO
SETUP" settings and override the previous
settings.
• Select "UNDO" to undo the last "AUTO SETUP"
settings and restore the previous settings.
• Select "DEFAULT" to reset the "AUTO SETUP"
parameters to the initial factory settings.
Note
"RELOAD" or "UNDO" is available only when you have
previously run "AUTO SETUP" and confirmed the results.
Press J ENTER to start the setup
5
procedure.
This unit starts the automatic setup procedure. Loud
test tones are output from each speaker during the
auto setup procedure. Once all items are set, the
"FINISH" display appears in the front panel display.
INITIALIZING
WIRING/LEVEL
DISTANCE
SIZE
FINISH
y
To cancel the automatic setup procedure, press J k.
Notes
automatic setup
• During the
any operation on this unit.
• We recommend that you get out of the room while this unit
is in the auto setup procedure. It takes approximately 3
minutes for this unit to complete the auto setup procedure.
procedure, do not perform
Optimizing the speaker setting for your listening room (YPAO)
6
Once all measurement items successfully,
"FINISH" appears in the front panel display.
The speaker for which the result of the automatic
setup appears automatically changes in order.
The distance between the speaker
and the listening position
FL: 3.3m
Speaker
FL/FR: Front left/right
C: Center
SL/SR: Surround left/right
SW: Subwoofer
y
To display the result of the automatic setup again, press
J k / n repeatedly.
Notes
• If you selected "RELOAD" in step 4, no test tones are
output.
• If an error occurs during the "AUTO:CHECK" procedure,
the setup procedure is canceled and an error screen
appears. For details, see "If an error screen appears" on
page 24.
• When this unit detects potential problems during the
"AUTO SETUP" procedure, "WARNING" and the
warning messages appears after this unit displays the
result of the automatic setup. For details, refer to the
"AUTO SETUP" section in "Troubleshooting" on
page 55.
• The distance measurement result may be longer than the
actual distance depending on the characteristics of your
subwoofer.
7
Press J l / h to select "SET" or "CANCEL".
Choices: SET, CANCEL
• Select "SET" to confirm the "AUTO SETUP"
results.
• Select "CANCEL" to cancel the "AUTO SETUP"
results.
+2
The result of the
adjustment of the
volume level
23
En