The Reset Button; Rebooting The Cable Gateway; The Usb Icon; Usb Cabling - Comcast WCG200 User Manual

The Reset Button

Pressing the Reset Button and holding it in for a few seconds will clear all of
the Cable Gateway's data and restore the factory defaults. This should be done
only if you are experiencing networking problems and have exhausted all of
the other troubleshooting options. By resetting the Cable Gateway, you run the
risk of creating conflicts between your PCs' actual IP Addresses and what the
Cable Gateway thinks the IP Addresses of the PCs should be. You may be
forced to reboot each network PC.

Rebooting the Cable Gateway

You should only reboot the Cable Gateway after all other troubleshooting
methods have been exhausted. There are two ways to reboot the Cable
Gateway:
1) Turn the Cable Gateway's power off for a few seconds and power it back on
again.
2) Unplug the Cable Gateway's power adapter and plug it back in again.
Rebooting the Cable Gateway may cause conflicts with IP Addresses.
6

The USB Icon

The USB icon, shown in Figure 2-3, marks a USB port on a PC or device.
Figure 2-2

USB Cabling

The Cable Gateway comes with one USB cable. One end of the USB cable is
connected to the Cable Gateway and the other end is connected to a computer's
USB port.
The picture shows two USB ports as they might appear on
your computer. Note the two USB icons marking the
ports.
Figure 2-3
7