Help Files Test Case - Symantec WISE PACKAGE STUDIO 8.0 - REFERENCE V1.0 Reference

Wise Package Studio Reference
To verify that the application accepts the command-line option and argument, run it
from the command line. If it fails from the command line, the command-line option and
argument are incorrect, or the program is not coded to accept them.
See also:
About Test Cases on page 164
Application Verification Tests

Help Files Test Case

Quality Assurance module only.
If Test Expert detects help files in a package, the Help Files test case appears. This test
searches the package for .HLP or .CHM files and lists them in the right pane. It verifies
that the files can be opened.
This test can be run only if the package being tested is currently installed.
To run the test case
1. Select the Help Files test case in the left pane of Test Expert.
All help files detected in the package are listed.
2. Mark the check boxes of the help files to test.
3. Click Execute.
The Test Case - Help Files dialog box appears, where you execute one test at a time.
4. Click Execute in the Test Case dialog box.
After a pause, the installed help file should open.
5. Close the help file.
6. When the Pass/Fail dialog box appears:
a. Click Pass or Fail based on your visual verification of the test results.
b. In Comments, enter any pertinent information about the test case.
7. In the Test Case dialog box, continue to click Execute for each subsequent test case,
entering Pass/Fail results for each.
When the tests are finished, the dialog box closes and the statuses are displayed in
the Status column.
8. Select the overall status of the test case in Status of Test Case.
To troubleshoot failures
Investigate what files, operating system, or other system requirements are necessary to
open help files.
See also:
About Test Cases on page 164
Application Verification Tests
on page 180
on page 180
Test Expert
183