Specifying Execute Program Settings - Symantec WISESCRIPT EDITOR 7.0 SP2 - FOR NS V1.0 Manual

WiseScript Editor Reference
Set Font
Normally, all controls use the default font, which you set on the Dialog Box
Properties dialog box. Click this to override the default font for this control. If
the font you select is not available on this computer, the system font is used.
Default Font
Click this to use the font specified on the Dialog Box Properties dialog box.
Transparent background
Mark this to make the background for this control transparent.
Calculated Value
This section is used primarily in component installations to display the space
requirements for the selected components. Example: When a component
installation is run, the Select Component Dialog displays the disk space required
and the disk space remaining. That information is provided by the following
fields:
Components
This variable represents the Disk Space Required by the selected component
set. Select the COMPONENTS variable, as it calculates the total space
requirements for the currently-selected component set.
Disk
This variable represents the Disk Space Remaining on the installation drive.
Select the MAINDIR variable, as it keeps track of free space in the
installation directory.
X-Position / Y-Position
Specify the exact location of the control on the dialog box. You can also use the
alignment commands to precisely arrange controls on the dialog box.
See Aligning and Spacing Dialog Box Controls
Note
A dialog unit is based on the size of the dialog font, usually 8-point MS Sans
Serif. A horizontal dialog unit is 1/4 the average width of the font and a vertical
dialog unit is 1/8 the average height of the font.
Width / Height
Specify the exact dimensions of the control in dialog units. You can also resize
controls by dragging their handles, though this is not as precise.
4. Click OK.
See also:
About Dialog Box Controls
About Dialog Boxes on page 92

Specifying Execute Program Settings

You can execute a program or link to a Web page when the end user clicks a hot text or
button control on a dialog box.
1. Open the Hot Text or Push Button Control Settings dialog box.
See Adding Hot Text Controls
page 107.
on page 94
on page 103 or Adding Push Button Controls
on page 113.
on
112