Applying Transforms To An Installation; Applying Or Removing Patches With A Command Line - Symantec WINDOWS INSTALLER EDITOR 7.0 SP2 - REFERENCE FOR WISE INSTALLATION EXPRESS V1.0 Installation Manual

Windows Installer Editor Reference
See Creating a Command Line To Apply to an Installation
Note
The Properties tab appears only when Install Mode on the General tab of the
Command Line Details dialog box is set to Install or Network Install.
2. Select a property in the left pane and click Add to copy it to the right pane.
3. In the right pane, enter the value for the property.
4. Click OK.
See also:
Creating a Command Line To Apply to an Installation

Applying Transforms to an Installation

Not available in a transform.
Command lines cannot be applied to a transform.
For information on transforms, see TRANSFORMS Property in the Windows Installer SDK
Help.
To apply transforms to an installation
1. Click the Transform tab on the Command Line Details dialog box.
See Creating a Command Line To Apply to an Installation
Note
The Transforms tab appears only when Install Mode on the General tab of the
Command Line Details dialog box is set to Install.
2. Click Add and specify the transform file (.MST).
The full path appears in Transform List.
3. Repeat the preceding step to specify additional transforms.
4. Because Windows Installer applies transforms in the order specified, adjust the
order of the transforms as needed.
5. Click OK.
See also:
Creating a Command Line To Apply to an Installation
Applying or Removing Patches With a Command
Line
Not available in a transform.
Command lines cannot be applied to a transform.
Advanced Installations
on page 223.
on page 223
on page 223.
on page 223
230