Dixon ZTR 6601 Operator's Manual page 21

OPERATION INSTRUCTIONS
In order to achieve optimum cutting performance, please read and follow the tips listed below.
Additional information can be found in the troubleshooting guide on Page 35.
1. Set engine speed control to the wide open or full setting.
2. Do Not Attempt To Cut Grass When It Is Wet. Wet grass will clog the underside of the deck and
discharge area.
3. If the grass is tall, place the mower deck cut height lever in the top or second notch. "Initially"
overlap cutting swaths instead of a full swath with each pass. Some applications may require a
second cutting.
4. Keep The Underside Of The Mower Deck Clean. Frequent removal of dried grass and dirt will
allow the clippings to discharge correctly.
5. Maintain Sharp Blade(s) Throughout The Cutting Season.
GRASS HEIGHT SUGGESTIONS:
Correct mowing height can reduce weeds and disease by 50 to 80%
The following grass cut heights are based on adequate moisture conditions and normal thatch
buildup in a healthy lawn. Some locations and applications may require slightly different cut heights.
If in doubt, consult your local lawn professional for assistance.
Be sure that deflector is properly installed on the
discharge chute.
Grass Types:
Zoysia
Blue Grass
Fescue Blends
St. Augustine (Mid South)
St. Augustine (Deep South)
Tifton Bermuda
Centipede
Common Bermuda
Bahia/Argentina/Pensacola
Best Cut Heights
2" - 2 1/2"
1 1/2" - 3"
1 1/2" - 3"
1 1/2" - 2"
3" - 4"
1 1/2"
1 1/2" - 2"
1 1/2" - 2"
2"
Page 18