Neutral Adjustment - Dixon Black Bear 11249-106 Safety And Operating Manual

CARE AND MAINTENANCE

NEUTRAL ADJUSTMENT

1. Lift seat.
2. Block up the unit so that the drive wheels are off the
ground. Remove rear tires.
3. Loosen jam nuts on both ends of the control rod
coupler. Note: The rear jam nuts are left hand
threads.
4. With steering control arms in the "out" neutral
position, start the engine and run at fast idle.
5. Adjust the neutral position by turning the control rod
coupler until the hubs do not rotate.
6. Re-tighten the jam nuts against the control rod
coupler and check to see that the drive wheels are
not turning.
7. Repeat steps 3-6 for the other side.
8. Shut off engine before reinstalling rear tires and
removing the blocks.
43