Power Cord; Power Button - Bissell OptiClean Bagged Canister User Manual

O
perations

Power cord

The power cord is located at the rear
of the vacuum. Gently pull out the
power cord, watching for the yellow
line. Stop pulling the power cord once
the yellow line is visible. There is also
a red line, which indicates the end of
the usable cord. Do not pull the power
cord out beyond the red line.

Power button

Turn the power ON or OFF by pressing
lightly downward on the power but-
ton ( ).
Automatic cord rewind
Your vacuum is equipped with an
automatic cord rewind. When clean-
ing is finished, press the power button
OFF ( )and grasp the plug to discon-
nect from the electrical outlet. Hold the
plug and press the automatic cord
rewind button to rewind the cord
automatically.
Variable suction power control
The variable suction power control
panel is located on the top of the vac-
uum. Press the
suction. Press the
suction, for lightly soiled areas or deli-
cate fabrics.
WARNING:
To reduce the risk of electric
shock, turn power switch
OFF and disconnect plug
from electrical outlet before
performing maintenance or
troubleshooting checks.
w w w . b i s s e l l . c o m
+
button to increase
–
button to decrease
Automatic
Cord Rewind
CAUTION:
Be careful to avoid injury as
cord retracts very quickly.
Variable Suction
Control
CAUTION:
Before using your vacuum,
make sure that the dust
bag and all filters (pre-
motor and post-motor) are
in place. Do not operate
your vacuum without the
dust bag and filters.
8 0 0 . 2 3 7 . 7 6 9 1
Power
Button
7