HP Integrity rx1600 Product Information page 2

Step 1. Remove the following components from your existing base unit. Refer to sections of the Operation
and Maintenance Guide, included on the hp Server Documentation CD-ROM for component
removal instructions.
Table 1 List of Components to be Removed
• Power Supply Fans
• Power Supply
• CPU airflow guide (single CPU systems only)
• Memory DIMMs
• DVD Filler (present when a DVD or CD-ROM
is not installed)
• Disk Filler(s) (present on disk-less systems)
• Management Processor card (optional card,
may be present)
Step 2. Install the previously removed components into the new base unit. Refer to sections of the
Operation and Maintenance Guide, included on the hp Server Documentation CD-ROM for
component replacement instructions.
Table 2 List of Components to be Replaced
• Power Supply Fans
• Power Supply
• CPU airflow guide (single CPU systems only)
• Memory DIMMs
• DVD Filler (present when a DVD or CD-ROM
is not installed)
• Disk Filler(s) (present on disk-less systems)
• Management Processor card (optional card,
may be present)
Step 3. You will have to reconfigure the system boot settings at EFI.
Step 4. Follow the instructions that accompany the new base unit to return the hardware to
Hewlett-Packard.
2
• Chassis Fans
• PCI I/O Backplane Assembly
• CPU(s) and associated Power Pods
• DVD or CD-ROM (if present)
• Disk(s)
• Display Panel
• Management Processor Blank (present when
Management Processor not installed)
• Chassis Fans
• PCI I/O Backplane Assembly
• CPU(s) and associated Power Pods
• DVD or CD-ROM (if present)
• Disk(s)
• Display Panel
• Management Processor Blank (present when
Management Processor not installed)