CAMBRIDGE 16716 Manual page 10

OPERATING INSTRUCTIONS
4.2 CONTROL PANEL OPERATING PROCEDURES (CONTINUED)
Flame Operation:
1. To switch on the flame, flip the FLAME POWER rocker switch to on.
The red LED light on the switch turns on.
2. To adjust the brightness of the flame, turn the right-hand dial clockwise,
marked FLAME, until it reaches the brightness you desire.
Heater Operation:
1. To switch on the heater, flip the FAN POWER rocker switch on.
The red LED light turns on.
2. Flip the second rocker switch from the left, marked Heater I.
This switch gives you approximately 750 W of power to your heater.
This switch is for low-level heating. For high-level heating, make sure that
the FAN POWER, HEATER I and HEATER II switches are all turned on.
3. To adjust the temperature, turn the left-hand dial clockwise,
marked TEMPERATURE CONTROL until it reaches the temperature you desire.
9
SECTION 4
Fig. 5
Fig. 6