Connectors; Power Supply - PRESONUS CENTRAL STATION User Manual

•
MIC – Connect dynamic microphone for external TALKBACK microphone via balanced XLR connector.
2 . 7 C O N N E C T O R S
All analog Input and Output connectors use the following standards:
2 . 8 P O W E R S U P P L Y
The external power supply included with your unit corresponds to the AC power requirements of the country in
which it was sold. Do not use your power supply if the AC Voltage on the power supply does not match the
power requirements of your country.
The CENTRAL STATION does not have a power ON/OFF switch. To power on your CENTRAL STATION
connect the locking round connector on the power supply to the CENTRAL STATION then connect the AC
connector on the power supply to your power source. You can connect your CENTRAL STATION power
supply to a power strip and use the switch on the power strip to turn your unit on and off.
Make sure you always turn off power amp and powered monitors before changing any cable
connections or turning your CENTRAL STATION on or off. Loud pops can clicks can occur when making cable
connections or powering up or down your CENTRAL STATION.
Analog 1/4" TRS and XLR
Analog RCA
Analog 1/4" TS (pedal)
Digital TOSLINK
Digital S/PDIF
CONTROLS & CONNECTIONS
Sleeve = GRND = Pin 1 XLR
Tip = Hot (+) = Pin 2 XLR
Ring = Cold (-) = Pin 3 XLR
Sleeve = GRND
Tip = Hot (+)
Sleeve = GRND
TIP = Hot (+)
Optical SPDIF stereo (not ADAT)
RCA, coaxial
Sleeve = GRND
TIP = Hot (+)
10