2005 Directed Electronics, Inc. Vista, Ca - Directed Electronics Hornet 564T Installation Manual

H H 2 2 / / 4 4 G G R R E E E E N N / / W W H H I I T T E E ( ( - - ) ) f f a a c c t t o o r r y y a a l l a a r r m m r r e e a a r r m m
This wire sends a negative pulse every time the remote start shuts down or the doors are locked. This can be used to
pulse the arm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the arm wire.
H H 2 2 / / 5 5 G G R R E E Y Y / / B B L L A A C C K K ( ( - - ) ) d d i i e e s s e e l l w w a a i i t t - - t t o o - - s s t t a a r r t t b b u u l l b b i i n n p p u u t t
Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-
board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK wire can be directly
connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must
be used to change the polarity. (See Finding the Wires You Need section of this guide.) Here are some common
colors of this wire:
■ Chevrolet and GMC trucks - Light blue or dark blue
■ Ford Trucks - Black/pink
■ Dodge Ram Trucks - Orange/black or black/orange
N N O O T T E E ! ! A 1-amp diode must be installed in line on the factory wire between the wait-to-start indi-
cator and the ECM. (See the following diagram for details.)
2 2 2 2
© 2005 Directed Electronics, Inc. Vista, CA