2005 Directed Electronics, Inc. Vista, Ca - Directed Electronics Hornet 564T Installation Manual

H H 1 1 / / 8 8 B B L L A A C C K K ( ( - - ) ) c c h h a a s s s s i i s s g g r r o o u u n n d d c c o o n n n n e e c c t t i i o o n n
Remove any paint and connect this wire to bare metal, preferably with a factory bolt rather than your own screw.
(Screws tend to either strip or loosen with time.) We recommend grounding all your components, including the
siren, to the same point in the vehicle.
H H 1 1 / / 1 1 0 0 B B R R O O W W N N ( ( + + ) ) s s i i r r e e n n o o u u t t p p u u t t
Connect this to the red wire of the siren. Connect the black wire of the siren to (-) chassis ground, preferably at
the same point you connected the control module's black ground wire.
H H 1 1 / / 1 1 1 1 R R E E D D ( ( + + ) ) 1 1 2 2 V V c c o o n n s s t t a a n n t t p p o o w w e e r r i i n n p p u u t t
Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant
12V supply to the ignition switch.
N N O O T T E E : : Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A
fuse in the harness for this purpose. This fuse protects the module itself.
H H 1 1 / / 1 1 2 2 R R E E D D / / W W H H I I T T E E c c h h a a n n n n e e l l 2 2 , , 2 2 0 0 0 0 m m A A ( ( - - ) ) o o u u t t p p u u t t
When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the red/white wire will
supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or
other relay-driven function.
2 2 0 0
© 2005 Directed Electronics, Inc. Vista, CA