Serial Plate Location - Kenmore 4559 - 30 in. Electric Drop-In Range Installation Instructions Manual

(if your appliance is equipped with a
white neutral conductor.)
This appliance is manufactured with a white neutral
power supply and a frame connected copper wire.
The frame is grounded by connection of grounding
lead to neutral lead at the termination of the conduit,
if used in USA, in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicles, where
local code do not permit grounding trough the neutral
(white) wlre or in Canada, disconnect the white and
green lead from each other and use ground lead to
ground unit in accordance with local codes, connect
neutral lead to branch clrcult-neutral conductor in
usual manner see Figure A. if your appllance is to
be connected to a 3 wire grounded junction box
(US only), where local code permit connecting the
appllance-groundlng conductor to the neutral (white)
see Figure 3.
NOTE TO ELECTRiCiAN: The armored cable leads
supplied with the appliance are UL-recognized for
connection to larger gauge household wiring. The
insulation of the leads is rated at temperatures much
higher than temperature rating of household wiring. The
current carrying capacity of the conductor is governed
by the temperature rating of the insulation around the
wire, rather than the wire gauge alone.
Where local codes permit connecting the appllance-
grounding conductor to the neutral (white) wire (US
Only) (see figure 1):
1. Disconnect the power supply.
2. In the junction box:
connect appliance and power supply cable wires as
shown in Figure 1.
Cable from Power Supply
White Wire -'_-_ J
(Neutra) r_ :L.L_.L___
Wires
Ground Wire __z _
(Bare or Green Wire) _--_
Black
_\.
!'_---- Juncti°n
i Box
_'_" (Neutral)
U.L.-Listed Conduit
Connector (or CSA listed)
Cable from appliance
Figure 1
3-WIRE GROUNDED JUNCTION BOX
If oven is used in a new branch circuit instaffafion
(1996 NEC), mobile home, recreatlonal vehlcle, or
where local codes DO NOT permit grounding through
the neutral (white) wire, the appliance frame MUST
NOT be connected to the neutral wire of the 4-wlre
electrlcal system. (see figure 2):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the junction box:
Connect appliance and power supply cable wires as
shown in Figure 2.
Cable from Power Supply
Ground Wire
Ground Wire
__'--_-_
(Bareor Green __
Junction Box _q-: _'S
hite Wire
Black
White W_'re
.....__ U.L.-Listed Conduit
Connector (or CSA
listed)
Cable from appliance
Figure 2
4-WIRE GROUNDED JUNCTION BOX
Serial Plate Location
You willfind the model and serial number printed on the
serial plate. The serial plate is located as shown.
Remember to record the serial number for future
reference,