Table of Contents
Advertisement
Name and function of parts
Front and side of the projector
AC IN terminal (page 33)
Connect the supplied line power cord into this
receptacle.
Do not connect any other cable to this socket.
MAIN POWER switch (page 33)
Use this switch to turn on "I" and off "
commercial line power applied to the projector.
Burglar lock
Attach a commercial burglar prevention cable (e.g.,
from Kensington) to this lock port. It is compatible
with the Microsaver Security System from
Kensington. Contact details for this company are
given below.
Kensington Technology Group ACCO Brands Inc.
2885 Campus Drive San Mateo, CA94403
Tel (650)572-2700
Fax (650)572-9675
http://www.kensington.com/
http://www.gravis.com/
Remote control receiver window (front) (page 15)
This window receives the signal beam emitted from
the remote control.
Power indicator lamp (page 33)
The lamp lights in red when the MAIN POWER
switch is turned to "I" (on). It turns to green when
the POWER ON button of the remote control or the
main unit is pressed.
LAMP1 monitor (page 96)
This lamp lights up when the time to replace lamp
unit 1 is reached. It also blinks if something
unusual occurs in the lamp circuit.
Projection lens (optional)
Lens for projecting images on the screen.
12
Projection lens cover lock button
This button toggles between lock and unlock of the
detachable cover for the projection lens (optional).
Temperature monitor (TEMP) (page 96)
Lighting or blinking of this lamp indicates an
o
" the
abnormal condition of the internal temperature.
LAMP2 monitor (page 96)
This lamp lights up when the time to replace lamp
unit 2 is reached. It also blinks if something
unusual occurs in the lamp circuit.
Air filter (page 97)
Level-adjusting feet (page 18)
Use these feet to adjust the tilt of the projector.
(Leveling feet are provided at the front and rear,
right and left.)
Side-mounted
connection terminals
(page 14)
Advertisement
Table of Contents
